Construction details for Mitrek radio

Using cor board 6.2

 


Introduction

This document shows construction and testing with cor board version 6.2; a prototype built for R&D, then in 2010 for a backup repair (FRU) serial # 44.

Some view angles of the cor board installed in a working (and standby FRU) "HUB" repeater for the 20 repeater (support). The front panel controls are easy to understand and adjust. The right shows the board flipped up for radio's PCB access as well.

 

 

 

 

 

 

The board is secured with three phillips head screws that go in the stock PL area. Those screws are a specific size, which is an M3.5 x 12 mm.

 

 




This may be copied in complete form only for non-profit purposes, such as for the knowledge for the Amateur Radio Service, with AK2O credited as designer. For other arrangements please contact the author. This documented has been updated on March of 2011.

Copy write: AK2O 2011 and later

[SRG home Direction]